wolfappliance.com | 7
INSTALLATION
5
Slide the upper chimney flue onto the support frame and
attach to the support frame using the screws provided.
Refer to the illustration below. Slide the lower chimney
flue over the upper and temporarily secure in this posi-
tion using adhesive tape.
6
Raise the hood to the support frame and connect the
hood to the support frame with the four screws provided.
Refer to the illustration below.
7
Insert the two prong connector from the hood into the
receptacle on the support frame.
8
Mount the electrical box to the wall using the support.
9
Insert the power supply from the home into the electrical
box.
10
Make electrical connections and install the cover.
11
Insert the plug into the receptacle on the top of the hood.
12
Once wiring connections are complete, remove the
adhesive tape securing the lower chimney flue, then
lower until it rests on the hood.
WARNING
Failure to install the screws or fixing device in accor-
dance with these instructions may result in electrical
hazards.
Installation
ISLAND HOOD
IMPORTANT NOTE:
The hood is wired for an internal
blower. If an in-line or remote blower will be used, refer to
In-Line / Remote Blower Wiring on page 9.
If an internal blower will be used, install the blower prior
to mounting the hood. Refer to page 8 for internal blower
installation.
1
Mark the centerline for the location of the four mounting
holes using dimensions shown in the illustration below.
Use the template provided to mark the mounting support
locations, then use a 1
1
/
4
" drill bit to create a hole for the
electrical power supply.
2
Place the four mounting screws into the ceiling, then
position the support frame on those screws. Once the
support frame is in place, tighten the screws.
3
Determine the desired height of the support frame and
adjust the height by removing the four screws. Once
the desired height is achieved, reinstall and tighten the
screws.
4
Place the damper on the support frame then attach
ducting to the damper.
8
5/8
"
(219)
ELECTRICAL
LOCATION
11"
(279)
Mounting location
Support frame
MOUNTING
SCREW
UPPER
FLUE
MOUNTING
SCREW
Install telescopic flue
Mount hood
