Page 47
How Do I Terminate/Unterminate AES Inputs?
AES signals should have one and only one termination. This termination should
physically be at the last destination of an AES coax cable. If the AMP2-16V is the
last connection in a series of AES connection, then its terminations should be
turned on. By default, the AES inputs of the AMP2-16V are all terminated.
A symptom of too many terminations (or no termination) is that no signal appears
to be present on the AES input.
The termination setup is done in the
AES Input Configuration Menu
:
Configuration Selection
Menu
Main Screen
Menu
Audio
Processors
Audio Processor Card Menu
AES Input Card
Configuration
AES Input
Configuration Menu
Figure 3–26: AES Input Configuration Menu
Save / Exit
Help
Cancel
1
2
3
4
5
6
7
8
AES
75-Ohm
Term
Terminate
All
AES Input Slot 4 Configuration Menu
Input Terminated
Input Not Terminated
1.
To terminate or unterminate all of the AES input pairs on the card in this slot,
press Terminate All. This is an alternate-action button.
2.
To terminate or unterminate one AES input pair, turn the AES 75-Ohm
Term control to select the desired AES input pair and then press it. This, too,
is an alternate-action button.
Содержание AMP2-16V-M
Страница 170: ...Page 163 Figure B 8 Deleting Stream Destinations...
