Wohler AMP2-16V-M, Руководство пользователя

Страница: 171 / 172

Page 164
Patch Panel
The Patch page enables routing of connections between listener and talker channels
for devices on the network. The highlighted green square indicates a routing
connection between a source or talker (left) and a destination or listener (bottom).
The Web GUI will allow selection of channels to monitor from among the listeners
(bottom).
The AMP2-16V is a destination only. Although many may be shown in the list,
you may route only to the TDM.0 and TDM.1 columns from any available source, as
follows:
TDM.0: Ravenna Pairs 1 - 4
TDM.1: Ravenna Pairs 5 - 8
All other columns are reserved and are ignored by the AMP2-16V.
In the event that the controller will not allow you to select either TDM.0 or TDM.1
as a destination, refer to the additional information under the Stream Destinations
section in this appendix.
Figure B–9: BACH Controller Patch Panel