Wohler AMP2-16V-M, Руководство пользователя

Страница: 164 / 172

Page 157
Home Page
You can navigate to different pages within the Bach Controller GUI to review or
perform various functions.
The Home page can be accessed by entering the 172.27.2.30 IP address. It gives
a device overview and stream status.
Note: The IP address given above is only the factory default setting, but you can
change it if necessary. Once you have changed it, only another BACH card can
discover the new IP address, and then only if it is on the same subnet.
Note: If you do change the IP address, make sure you document this change by
writing down the new IP address and affixing it to the rear panel cover plate of the
associated Ravenna option card for your future reference.
Figure B–2: BACH Controller Home Page
Configuration/Device Management
The first step in setting up the Ravenna option is to configure the Ethernet IP
address and other settings. The Device Configuration page allows operations such
as modifying the IP address, Packet time, Rebooting etc.
Note: There are important considerations when setting up a Ravenna network.
Ideally, the Ravenna network must be completely isolated from other Ethernet
devices, such as computers, printers, and connections to the internet. This is
because the timing of the communications on the Ravenna network is very critical.