15
Step 3
,
Click
to complete config.
3.1.1.5 Day & Night
The function can be used to set the conversion between color mode and B/W mode, which can effectively
guarantee that it can still monitor clear image even in dark environment for the intelligent speed dome. The config
steps are shown as follows.
Step 1
,
Select “Setup > Camera > Conditions > Day & Night”. The system displays the interface of “Day & Night”
mode, which is shown in Figure 3.1-9:
Figure 3.1-9 Day & Night
Step 2
, Configure parameter info according to the actual needs; refer to Table 3.1-3 for more details.
Parameter
Description
Type
Day/night switch mode can select electrical and ICR, it is ICR by default.
● ICR: Mechanical day/night switch uses filter for day & night switch.
● Electrical: It uses image processing mode for day & night switch.
Mode
Set image color and B/W mode, which is not influenced by the selection of config profile. It
is Auto Mode by default.
● Color: The camera will only output color image.
● Black & White: The camera will only output black & white image.
● Auto: It can select to output color or black & white image according to the environment
adaptation.
Sensitivity
Adjust the sensitivity of switch between Color and Black & White.
It can select Low, Middle and High, it is Middle by default.
Delay
It is used to adjust the delay value of switch between Color and Black & White. (Range: 2s
to 10s)
Table 3.1-3 Day&Night Parameter Description
Step 3
, Click
to complete config.
3.1.1.6 Zoom Focus
Digital zoom means zooming in part of the image, the bigger it zooms in, the more blurry it becomes.
Step 1
,
Select “Setup > Camera > Conditions > Zoom Focus”. The system displays the interface of “Zoom Focus”,
