wiwa PUGUN 4040, Руководство по эксплуатации

Страница: 38 / 60

6.3 Tools required
For cleaning, conversion or maintenance work on the spray gun, you need
various special tools.
With the full equipment (PU gun with accessories), these tools are contained
in the spray gun's transport case.
We recommend always keeping these tools there for further use.
Designation Order No. Use
Twist drill set, 9 piece
ø (mm): 0.5 + 0.7 + 1.0 + 1.3
+ 1.5 + 1.6 + 1.7 + 1.8 + 2.0
0657782 Cleaning the mixing chamber
Twist drill set, 1 piece
ø (mm): 2.5 0658139 Cleaning the flat stream tip
=> only included when the flat
stream tip is supplied
Tool holder 0.1 to 3.3 mm 0654519 Drill bit container
Grease pump including 85 g
multi-purpose grease
0654512 Lubrication
Combination spanner,
SW 13 + SW15 + flat-head
screwdriver
0657438 Manifold assembly/
disassembly
The selection of the drill required depends on the mixing chamber which is
fitted.
Mixing chamber ø drill size (mm/inch)
0656909
0657336 0.7 / 0.03
1.5 / 0.06
1.6 / 0.06
0657333
0657337 0.5 / 0.02
1.3 / 0.05
1.5 / 0.06
0657334
0657338 1.3 / 0.05
1.5 / 0.06
2.05 / 0.07
0657335
0657339 1.0 / 0.04
1.5 / 0.06
1.8 / 0.07
Additional tools required
To clean the spray gun, and in particular the nozzle and mixing chamber, we
recommend having various brushes to hand.
These are not supplied with the spray gun.
You can order a 17-part cleaning brush set from
WIWA , order no. 0654823.
Cleaning, maintenance and repair
6-4 Translation of the original operating manual
•1306Rev03_550014_PUGUN4040_en•ski