TK
+
ATEX
Assembly
Revision: 02a
2022-D034859
en-13
5
Assembly
Be informed of the general safety instructions before beginning work. (see Chapter 2.7
"General safety instructions").
5.1
Preparations
Clean / De-grease the following components with a clean and lint-free cloth and grease-
dissolving, non-aggressive detergent:
- All fitting surfaces to neighboring components
- Centering
- The motor shaft
- The inside diameter of the clamping hub
- The bushing inside and out
Dry all fitting surfaces to neighboring components in order to achieve the proper friction values
of the screw connections.
Check the fitting surfaces additionally for damage and impurities.
5.2
Installation conditions
5.3
Mounting the motor onto the gearhead
Ensure that the motor is mounted if possible in a vertical direction.
Pressurized air can damage the gearhead seals.
Do not use pressurized air to clean the gearhead.
Directly sprayed cleaning agents can alter the frictional values of the
clamping hub.
Only spray cleaning agents onto a cloth, with which you can then clean
the clamping hub.
Provide a metallic frame for connection of the gear reducer.
Provide a ground in the areas of the motor gear and gear-gear connection, so as
to prevent any electrostatic charge that may arise.
A damaged coupling can cause ignition dangers.
Align the shaft ends of the motor and gearhead precisely. The offset
values in table "Tbl-8" must
definitely
be maintained.
Observe the general information and safety instructions of the motor
manufacturer.
Observe the safety and processing instructions of the screw-bonding
agents to be used.
