Technical data sheets
LP
+
/LPB
+
en-8
2022-D039182
Revision: 03
Coat the four screws (E) with a threadlocker (e.g. Loctite 243).
Fasten the motor (C) onto the adapter plate (D) with the four screws (E).
Tighten the threaded pin (B) of the plug receptacle (A).
For screw sizes and prescribed tightening torques refer to Chapter 3.9 "Specifications for
fastening to a motor", Tables "Tbl-11".
Press the enclosed stopper plugs up to their stop in the mounting bores of the adapter
plate (D).
3.5
Mounted components on the gear output side
3.5.1
Mountings on the output flange (LPB
+
)
Designation
A
Plug receptacle
B
Threaded pin
F
Bushing
G
Smooth shaft
H
Keyed shaft
Tbl-6: Arrangement of motor shaft, plug receptacle and bushing
Distortions during mounting operations can damage the gearhead.
Mount gearwheels and toothed belt pulleys onto the output shaft without
forcing.
Do not on any account attempt an assembly by force or hammering!
Only use suitable tools and equipment for assembly.
If a gear wheel is pulled or shrink-fit onto the output shaft, make sure that
the maximum permitted static axial forces of the output bearing (see
table "Tbl-7") are not exceeded.
Size LP
+
/ LPB
+
050
070
090
120
155
F
a max
[N]
1800
4300
5100
11300
18500
Tbl-7: Maximum permitted static axial forces at static bearing statistic (s0) = 1.8 and radial force (Fr) = 0
Observe the safety and processing instructions of the cleaning agents
and screw-bonding agents to be used.
Only the version LPB
+
features an output flange on
which a toothed belt pulley can be mounted with the
bolts.
Thoroughly clean the output flange, centering,
fitting surface and toothed belt pulley. The anti-
corrosion agent on the toothed belt pulley must
be removed.
To remove the Aceton or Loctite 7063 anti-
corrosion agent, use a clean, lint-free cloth.
Also clean the browned toothed belt pulley with a
brush and remove any salt residue between the
flanged wheel and toothed belt wheel.
B
G
F
A
H
