AC Powered Wireless Microwave Motion & Light Sensor
Cyrus AM
WARNING AND GUIDELINES!!!
DO NOT INSTALL DAMAGED PRODUCT!
This product has been properly packed so that
no parts should have been damaged during transit. Inspect to confirm. Any part
damaged or broken during or after assembly should be replaced.
WARNING :
TURN THE POWER OFF AT THE CIRCUIT
BREAKER BEFORE WIRING
REQUIRED TOOLS & SUPPLIES
INSTALLATION INSTRUCTIONS
Turn off the power before wiring and installing the device
Power the sensor by connecting the AC Line and Neutral wires from the mains supply to the Line (Black color), and Neutral (White color) from the sensor.
Make a hole of 78mm diameter in the false ceiling where the sensor
is to be installed and take out the main supply wires
Wiring the sensor
Read and follow all safety instructions!!
Do’s
Installation should be performed by a
qualified electrician
Dont's
Don't use outdoors
Installation shall be in accordance with
all applicable local and NEC codes
Avoid input voltage exceeding
maximum rating
Turn the power OFF at circuit breakers
before wiring
Don't disassemble the products
Observe the correct polarity of output
terminal
-
Electrostatic Discharge (ESD): ESD can damage product(s). Personal grounding
equipment should be worn during all installation or servicing of the unit
Do not stretch or use cable sets that are too short or are of insufficient length
Do not modify the product
Do not mount near gas or electric heater
Do not change or alter internal wiring or installation circuitry
Do not use product for anything other than its intended use
WARNING: Risk of Product Damage
Verify that supply voltage is correct by comparing it with the product
information
Make all electrical and grounded connections in accordance with the National
Electrical Code (NEC) and any applicable local code requirements
All wiring connections should be capped with UL approved recognized wire
connectors
All unused wiring must be capped
WARNING - Risk of Electric Shock
Ceiling mount: Sensor can be installed in the false ceiling using the flush
mounted accessory, such as the clips, as given in the steps below
CEILING MOUNT
Mounting sensor on false ceiling
Specifications
Value
Remarks
Input voltage
90–277VAC
Input current
9mA@230VAC
15mA@90VAC
Inrush current
4A
4kV
0–80ºC (32 to 176°F)
2.3 X 2.5in
(59.8 X 63.1mm)
85g (3.0oz)
70°C (158°F)
ABS Plastic
Rated input voltage
_
_
_
_
_
Diameter x Height
In grams
White
INSTALLATION AND QUICK START SHEET
PRODUCT OVERVIEW
Cyrus AM is a BLE5.2 controllable high bay Microwave motion and daylight sensor. This
sensor operates on a 90-277VAC input voltage range adopts a 5.8GHz Microwave sensing
technology for accurate motion detection. It can be mounted at a maximum height of
12m(39.4ft) and provides a maximum detection range of 17m(55.8ft) diameter. The sensor
can be mounted to the ceiling or at the surface using ceiling or surface mount accessories.
It can be quickly commissioned, configured, and controlled from any mobile device and
can be connected to Lumos Controls cloud for data analytics and configuration
management
Wire connector
Screwdriver
Screws
Double sided
electrical tape
Electrical wires
Surge rating
Operating temperature
Case temperature
Case material
Dimensions
(Excludes accessories)
Diameter x Height
Dimensions
(Ceiling mount accessories)
Diameter x Height
Dimensions
(Surface mount accessories)
Net weight
(Excludes accessories)
Line
Neutral
1.
78mm
1
Electrical box
WMAM-CMK
WMAM-SMK
3.53 x 2.62in
(89.7 x 66.8mm)
4.32 x 2.80in
(109.8 x 71.2mm)
