WBD100
User Guide
I. Product Overview
1. Camera Detection Lens
2. Vibration Mode
3. Beep Mode LED
4. Laser Mode LED
5. Extendable Antenna
6. Mode Button
7. Low Battery LED
8. Weak RF Signal/Slow Blinking Laser LED
9. Normal RF Signal/Medium Blinking Laser LED
10. Strong RF Signal/Fast Blinking Laser LED
11. Strongest RF Signal LED
12. Laser Blinking Adjustment Button
13. Sensitivity Wheel
14. Headphone Jack
15. Power Input
16. Power Switch
17. Laser LEDs
II. What’s in the Box
-1× Anti-Spy Detector
-1× AC110-240V to DC5V Charger
-1× Headset
III. Radio Frequency Detection
>> Before using, please make sure that the detector is fully charged.
3.1. To power on the detector, slide the Power Switch to the ON position.
3.2. Press the Mode Button once to switch to beep mode and the beep mode LED
will glow solid orange. Or you can press the Mode Button once again to switch to
vibration mode and the vibration mode LED will glow solid orange.
3.3. Push up the sensitivity wheel and extend the antenna to the longest to widen the
search scope.
3.4. If RF signals are detected, the detector will either start beeping or vibrating.
Judging by the 4 signal LEDs, you can tell how strong the RF signals are.
3.5. Gradually push back the sensitivity wheel and shorten the antenna to narrow
down to the source of the radio signal. When closest to the objects emitting RF sig-
nals, all 4 signal LEDs will come on and stay illuminated.
3.6. Power off the detector by sliding the Power Switch to the OFF position.
[Note]:
The detector is in laser LED mode by default.
IV. Camera Lens Detection
>> Before using, please make sure that the detector is fully charged.
4.1. To power on the detector, slide the Power Switch to the ON position.
4.2. All 6 laser LEDs will keep flashing.
4.3. Give the Laser Blinking Adjustment Button a short press to make the laser LEDs
flash faster.
4.4. Look through the camera detection lens and you will find a blinking red dot
where the camera lens locates at.
4.5. Power off the detector by sliding the Power Switch to the OFF position.
V. Charging
5.1. Power off the detector and connect it to an outlet AC power supply using the
included DC5V charger.
5.2. It will take 2 hours to obtain a full charge.
5.3. The low battery LED will blink if the detector is running low on batteries.
5.4. The detector can run up to 6 hours on a full charge.
