Wisenet TNO-X6072EPT1-Z, Руководство по установке

Страница: 10 / 28

Electrical Power:
The “ TNO-X
nnnn
EPT1-Z " Series IP cameras operate from a variety of power options including IEEE
802.3af compliant POE devices.
The power supply used with this product shall fulfill the requirements for Safety Extra Low Voltage (SELV)
and Limited Power Source (LPS) according to IEC/EN/UL 62368-1 or IEC/EN/UL 60950-1 or Listed Class II
Power Source Equipment. The product shall be grounded either through a shielded network cable (STP)
or other appropriate method.
Camera Location:
The “ TNO-X
nnnn
EPT1-Z " Series IP camera must be installed in a suitable location away from impacts,
heavy vibration and extreme heat. The “ TNO-X
nnnn
EPT1-Z " Series camera must not be installed in an
area classification for which it is not rated. The “ TNO-X
nnnn
EPT1-Z " Series camera must be attached
securely and appropriately to a wall or supporting structure.
CAUTION: The electrical cover should never be removed unless power
is removed (for at least 5 minutes) from the unit or the area is known not
to contain hazardous gases.
WARNING
• The product shall be installed by a trained professional.
• The product shall be used in compliance with local laws and regulations.
• Store the product in a dry and ventilated environment.
• Avoid exposing the product to shocks or heavy pressure.
• Do not install the product on unstable brackets, surfaces or walls.
• Use only applicable tools when installing the product. Using excessive force with power tools could
cause damage to the product.
• Do not use chemicals, caustic agents, or aerosol cleaners.
• Use a clean cloth dampened with pure water for cleaning.
• Use only accessories that comply with the technical specification of the product. These can be provided
by Spectrum , Hanwha, or a third party.
NOTE:
General Safety and Operating Information:
10