English
_7
●
INST
ALLA
TION
5.
Adjust camera angle as needed.
6.
Connect the camera cable to the camera.
Take caution when installing the camera
outdoors because the cable connectors
may be wet with moisture or pile up with
impurities.
Although the camera is IP66 rated, direct
exposure to water or moisture may cause
problem such as condensation.
PROTECTION OF CABLE FROM WATER
If this product is mounted outdoor, water leakage may occur at gap between cables. As shown below, butyl rubber
(available on the market) shall be used to protect from water.
1.
Connect power supply and BNC power source.
2.
Cover black sheath of the cable (Zone A), and ensure half of
butyl rubber can cover the cable joint.
J
`
Poor water protection at the cable sheath may cause water
leakage. Make sure to wrap tightly.
`
The water-proof butyl rubber is made of rubber that expands to
twice the original length.
`
If you do not use cable joint, it must be covered with water-proof tape.
CONNECTING THE DVR
Connect the BNC connector of the camera to the enclosed 60ft camera cable, and then connect the BNC
connector of the camera cable to the BNC Video Input port of the DVR.
12V
CAUTION
RISK
OF ELECTRI
SHOC
K
DO NO
T OPEN
CAUTION : TO REDUCE THE RISK OF ELECTRICAL SHOCK
DO NOT OPEN COVERS. NO USER SER
VICEABLE
P
ARTS INSIDE. REFER SER
VICING TO QUALIFIED
SER
VICE PERSONNEL.
WARNING : TO PREVENT FIRE OR SHOCK HAZARD. DO NOT
EXPOSE UNITS NOT SPECIFICALL
Y DESIGNED
FOR OUTDOOR USE TO RAIN OR MOISTURE.
VIDEO INPUT
VGA
HDMI
LAN
