Wisenet QNP-6320HS, Руководство пользователя

Страница: 12 / 23

installation & connection
12_
installation & connection
Notes for Waterproofing
` Installing the unit on the wall by combining the outdoor housing and wall mount
1. Install the wall mount on the vertical wall. If the mount is
installed on an inclined wall, moisture can penetrate inside the
outdoor housing through the external cable.
2. Wrap the screw part of the housing with a sufficient amount of
Teflon tape for assembly.
3. When separating the dome cover and fastening it to the
housing frame, make sure that the gasket is not loosened to
separate from the dome cover.
4. Install the wall mount adapter for waterproofing, and apply the
silicon sealant between and around the wall and wall mount for
sealing.
J
`
Take particular caution to ensure that there is proper sealing if the
installed side is not flat.
` Installing on the wall by combining the outdoor housing and ceiling mount adapter
1. Wrap the screw part of the housing with a sufficient amount
of Teflon tape for assembly.
2. When separating the dome cover and fastening it to the
housing frame, make sure that the gasket is not loosened to
separate from the dome cover.
3. Install the ceiling mount adapter for waterproofing, and apply
the silicon sealant between and around the wall and ceiling
mount for sealing.
J
`
Take particular caution to ensure that there is proper sealing if the
installed side is not flat.
Wall mount
Silicon
sealant
Concrete wall
Screw
unit
Teflon tape
Dome gasket
Ceiling mount
adapter
Screw
unit
Ceiling board
Silicon
sealant
Teflon tape
Concrete ceiling
Dome gasket
CONNECTING WITH OTHER DEVICE
Powering and networking
Connect the PoE+ supported router or PoE+ injector with the PoE port of the camera.
PoE+ device
J
`
The product cannot be used at -40°C or below ambient temperature.
`
The product may not be defrosted depending on the installation area at -40°C.
`
After the product is left alone under a low temperature environment, it will take up to 2 hours to normally operate.
` If the product is turned on after being exposed to -20°C or below environment for some time, reset the time.
` Use a PoE+ device that complies with the IEEE 802.3at standard.
- If your device is connected to the switch with the standard of PoE (IEEE 802.3af), then go to the switch setup menu to
“deactivate PoE”.
For further information on switch device, refer to the manufacturer’s manual.
- It is recommended to use a cable that complies with the PoE+ spec.
`
Depending on your PoE+ device, the boot time (including PoE+ power connection time) might vary.
M
`
Use an STP cable to increase the protection from thunderstroke damage.