Wisenet QNP-6250, Руководство пользователя

Страница: 24 / 35

installation & connection
24_
installation & connection
CONNECTING WITH OTHER DEVICE
Powering and networking
Connect the PoE+ supported router or PoE+ injector with the PoE port of the camera.
<
QNP-6320/QNP-6250
> <
QNP-6320H/QNP-6250H
>
PoE+ device
J
`
The product cannot be used at -40°C or below ambient temperature.
`
The product may not be defrosted depending on the installation area at -40°C.
`
After the product is left alone under a low temperature environment, it will take up to 2 hours to normally operate.
` If the product is turned on after being exposed to -20°C or below environment for some time, reset the time.
` Use a PoE+ device that complies with the IEEE 802.3at standard.
- If your device is connected to the switch with the standard of PoE (IEEE 802.3af), then go to the switch setup menu to
“deactivate PoE”.
For further information on switch device, refer to the manufacturer’s manual.
- It is recommended to use a cable that complies with the PoE+ spec.
`
Depending on your PoE+ device, the boot time (including PoE+ power connection time) might vary.
M
`
Use an STP cable to increase the protection from thunderstroke damage.
Network Cable Specification
Item Contents Remark
Connector RJ45 (10/100BASE-T)
Ethernet 10/100BASE-T
Cable UTP Category 5e
Max Distance 100 m DC Resistance ≤ 0.125 Ω/m
PoE Support PoE+
installation & connection