Wisenet LRN-810S, Руководство пользователя

Страница: 69 / 123

English
_69
802.1x
When connecting to a network, you can select whether to use the 802.1x protocol and install a corresponding
certificate.
802.1x is an authentication system between a server and a client, which prevents hacking, virus infection, and
information leakage of transmitted and received network data.
802.1x can be used to block the unauthorized client access and increase security by allowing only authenticated
users to communicate.
Setup > Network > 802.1x
●
EAPOL version : Select the EAPOL version to be used as protocol.
￭
Some switch hubs will not operate if you set them to version < 2 >. Select the version < 1 >, which is the EAPOL default.
●
ID : Enter the ID provided by the RADIUS server administrator.
￭
If the entered ID does not match the ID of the client's certificate, it won't be processed properly.
●
Password : Enter the password provided by the RADIUS server administrator.
￭
If the password you entered does not match that of the client's private key, it won't be processed properly.
●
Certificates : Search for a device. Click on < > to search for a device again.
●
CA certificates : Select this only if your public certificate includes the public key.
●
Client certificate : Select if the public certificate includes a client's authentication key.
●
Client private key : Select it if the public certificate contains the client private key.
￭
For successful implementation of the 802.1x operating environment, the administrator must use the RADIUS server.
In addition, the switch hub connected to the server must be a device that supports 802.1x.
￭
If the time setting of the RADIUS server, the switch hub and an recorder do not match, communication between them can fail.
￭
If a password is assigned to the client's private key, the server administrator should confirm the ID and password.
The ID and password allow up to 30 characters each. (But it only supports letters, numbers and special characters ("-", "_", ".” 3 types) only.
Accessing non password-protected files is allowed without entering a password.
￭
The 802.1x protocol adopted by the Recorder is EAP-TLS.
￭
You need to install all three certificates to use 802.1x.
E-mail
You can send an e-mail to a Recorder-registered user at a specific time interval, or if an event occurs.
SMTP Setting
Sets the SMTP mail server.
Setup > Network > E-mail > SMTP
●
Server address : Enter the SMTP server address to connect to.
●
Port : Enter the connection port.
●
Enable authentication : Check this if the SMTP server uses user authentication.
The ID and password fields will be activated when the authentication is enabled.
– ID : Enter a ID to use authentication when connecting to the SMTP server.
– Password : Enter the password of the SMTP server user.
●
Enable Transport Layer Security (TLS) : Select one from < Never > and < TlS (if available) >.
●
Sender : Use the virtual keyboard to enter the sender's e-mail address.
●
Test e-mail : Conducts the test on the server settings.
•
SE
Tu
P