Wisenet HCP-6230, Руководство пользователя

Страница: 81 / 93

English
- 81
●
setup
iniTialiZE
z
Power on reset :
Restarts the camera.
z
factory Default set :
Enables resetting the camera to its factory default settings. When
the mode is selected, all custom data such as preset locations is
deleted from the camera.
Use this function if it is necessary to reset the settings of the
camera.
[Current Time], [Language] and [Fan Life] values maintain the
current values rather than the default values.
z
Camera Default set :
Reset the zoom module of the camera to the factory default. Use
this if you want to return the camera settings of such as Exposure
or Backlight to the factory default.
z
auto refresh :
Optimizes the settings of the electric circuits and component parts
of the camera on a regular basis.
This is useful for maintenance purpose, especially when the
camera faces a specific light source, or if the camera settings are
not maintained properly due to an extended time of recording
while rotating the camera in four directions.
- Off, 1~7 Days : Selecting Off disables Auto Refresh and selecting
1~7 Days automatically executes it after 1~7 days has passed.

Auto Refresh takes about 10 seconds or less. Any sequence operation that is being performed will
be stopped and resume after Auto refresh is completed.
z
fan life (applied only to Environmental models)
:Enables setting the Fan Life.
- Message Display: Two months before pan life termination (1440 hours), the following warning
message will appear. “Fan Life Expired. Replace the Fans”
f ON: Display the warning message. (Default)
f OFF: Do not display the warning message.

[OFF] is to hide the message, rather than to delete it. Set it back to [ON]. Then, the warning
message will appear. (Only if you didn’t clear the message [Message Clear])
- Message Clear: Use this if you want to delete the warning message when it pops up.

If you set [Message clear] to [On]after performing the command, no warning message will appear
on the screen.
- Time Reset: Set to count the fan life again after replacing the fan. (However, this is available only
after you see a warning message that the fan life has expired.)

The fan life is counted only for an actual operation so the fan can be used longer than the
displayed time.
- Time Remain.(hour):
f
49000 : Remaining life of fan (unit: hour)
f
The fan life will be updated when you access the [Fan Life] menu and if you press [ENTER] on the
[Time Remain.(hour)] item.
Initialize
Power On Reset
Factory Default Set
Camera Default Set
Auto Refresh
OFF
Fan Life
Main Menu
Camera Setting
Sequence Setting
P/T Setting
OSD Setting
Alarm Setting
Initialize
Password Setting
Status
