Wisenet CT-TNV-8011C, Руководство пользователя

Страница: 8 / 26

overview
8_
overview
AT A GLANCE
a
b
c
Appearance
Item Description
a
Top Cover Case cover used to protect the lens and the main unit.
b
Camera module
Body part where the camera lens and connection terminals are included.
c
Camera case This is used to install a camera on the ceiling.
Components
a
b
c
d e
f
Item Description
a
MICRO USB port
Port to connect the WiFi dongle.
You can check the installation video through the applications installed in the smartphone.
Refer to “
Connecting WiFi ” on page 14.
` Wifi dongle and OTG adapter are sold separately.
b
Test monitor out port
Output port for test monitoring the video output. Use the test monitor cable to connect to a
mobile display and check the test video.
c
Reset Button
The button restores all camera settings to the factory default.
Press and hold for about 5 seconds to reboot the system.
J If you reset the camera, the network settings will be adjusted so that DHCP can be
enabled. If there is no DHCP server in the network, you must run the Device Manager
program to change the basic network settings such as IP address, Subnet mask,
Gateway, etc., before you can connect to the network.
d
Micro SD card slot Compartment for the Micro SD card.
e
Audio / alarm cable port
Port to connect audio and alarm cables.
ARM-IN Used to connect the alarm input sensor or external day/night sensor.
ARM-OUT Used to connect the alarm output signal.
GND These are common ports to connect alarm input/output signals.
MIC Used to connect to a microphone.
SPEAKER Used to connect to speakers.
f
Network Port Used to connect the PoE or Ethernet cable for network connection.