English _
13
●
●
INST
ALLA
TION & CONNECTION
Installation on a ceiling or wall
1.
Use the provided template to drill holes for installation (diameter
6 mm and minimum depth 45mm) and insert the supplied plastic
anchors to the end.
2.
Align the holes of the mount plate for installation with the holes
inserted with plastic anchors, and fasten the tapping screws.
3.
Connect the safety wire.
4.
Mount the camera body to the mount plate.
`
Mount it to fit the hinges as shown in the image.
5.
Connect the terminal inside camera with the required
cable.
J
`
If the lens module is not attached correctly, the lens module
status light will illuminate red, as shown in the figure. If this
occurs, turn off the power switch and reattach the lens module.
If attached normally, it will illuminate green and then turn off
after approximately 40 seconds.
6.
Push in the mounting clip.
7.
Adjust the lens to the desired direction by referring to
“
Adjusting the monitoring direction for the camera
”.
(Page 17)
`
If you tilt the lens, you may need to adjust the lens as this may block the screen.
8.
Assemble the dome cover.
`
Align the arrows when assembling the dome cover.
`
To ensure there are no issues with waterproofing, tighten the fastening bolts
tightly using the Torx L wrench or screw bit.
FRONT
FRONT
VIDEO
CH1
CH2
CH4
LENS
CH3
RESET
CH
1
0
1
0
1
1
1
0
0
2
ON
RESET
1
2
3
4
CH 4
CH 3
CH 2
CH 1
ON / OFF
Ple
ase
turn off whenyou chang
e
lens module.
LENS
1
VIDEO
CH
00 : CH 1
10 : CH 2
01 : CH 3
11 : CH 4
2
3
4
FRONT
LINK
00:CH1
01:CH2
10:CH3
11:CH4
ACT
LINK
00:CH1
01:CH2
10:CH3
11:CH4
ACT
