installation & connection
10_
installation & connection
installation & connection
INSTALLATION
J
`
This camera is waterproof and in compliance with the IP66 spec, but the jack connected to the external cable is not. You are
recommended to install this product below the edge of eaves to prevent the cable from being externally exposed.
Precautions before installation
Ensure you read out the following instructions before installing the camera:
•
Select an installation site that can hold at least 5 times the camera’s weight.
•
Stuck-in or peeled-off cables can cause damage to the product or a fire.
•
For safety purposes, keep anyone else away from the installation site.
And put aside personal belongings from the site, just in case.
•
If the product is installed with excessive force, it may cause damage to the camera due to malfunction.
Forcing assembly using non-compliant tools may damage the product.
•
Do not remove the lens module while the power is on.
Disassembling
1.
Remove the dome cover by loosening the fastening
bolt of the dome cover. This can be done by turning it
counterclockwise using the Torx L Wrench or screw bit
provided.
2.
Loosen the fastening screw on the camera body.
3.
Remove the camera body and mounting plate by pulling the mounting
clip, as shown in the figure.
Inserting a Micro SD card
1.
Remove the dome cover of the camera.
2.
Insert a Micro SD card in the arrow direction shown in the figure.
J
`
Disconnect the power cable from the camera before inserting the Micro SD card.
`
Do not forcefully insert it in the reverse direction. It might damage your Micro SD card and your product.
`
When it rains or the humidity is high, insertion or ejection of a Micro SD card is not recommended.
`
Disassembly of the product cover should be finished within 5 minutes, or there will be the risk of internal dew condensation.
LINK
00:CH1
01:CH2
10:CH3
11:CH4
ACT
LINK
00:CH1
01:CH2
10:CH3
11:CH4
ACT
Dome cover
Mount plate
Fastening bolt
Camera Body
VIDEO
CH1
CH2
CH4
LENS
CH3
RESET
CH 1
0
1
0
VIDEO
CH1
CH2
CH4
LENS
CH3
RESET
CH 1
0
1
0
VIDEO
CH1
CH2
CH4
LENS
CH3
RESET
CH 1
0
1
0
VIDEO
CH1
CH2
CH4
LENS
CH3
RESET
CH 1
0
1
0
1
1
1
0
0
2
ON
RESET
1
2
3
4
CH 4
CH 3
CH 2
CH 1
ON / OFF
Ple
ase
turn off whenyou chang
e
lens module.
LENS
1
VIDEO
CH
00 : CH 1
10 : CH 2
01 : CH 3
11 : CH 4
2
3
4
