Wirepath Surveillance WPS-550-DOM-IP, Руководство пользователя

Страница: 51 / 63

51
© 2014 Wirepath Surveillance
WPS-550-DOM-IP Installation Manual
9.5.1.1. Record File
2
File Format
Selects the file type to create when the event occurs:
• AVI File – Creates a short .AVI format video file.
• JPEG Files (Streaming 1 must be set MJPEG) – Creates a series of JPEG files at about 1 FPS.
• JPEG File (Single JPEG at Interval) – Creates a single JPEG image file at time of event.
Note: JPEG Files (Streaming 1 Format must be MJPEG) saves or sends 10 JPEG images taken
approximately 1 second apart. Video Settings / Streaming 1 Format MUST be set to MPEG in order to
select this option.
Click “Apply” at the bottom-right of the page to save modified settings.
9.5.1.2. Record Time Setting
3
Pre/Post
Alarm
Pre Alarm – Amount of time prior to the event to start the recording, from 0-5 seconds.
Post Alarm – Amount of time after to the event to stop the recording, from 0-10 seconds.
Note: The camera cannot record intervals for motion events longer than 15 seconds in one video clip.
Multiple recordings will be saved for motion events longer than the time set Motion Detection “Interval”
section. In such cases there may be a gap of several seconds between recordings.
Click “Apply” at the bottom-right of the page to save modified settings.
9.5.1.3. Network Disconnected
4
Disconnected
When checked, the camera will record event video to the microSD card (if installed) when the camera
loses network connection.
Click “Apply” at the bottom-right of the page to save modified settings.
9.5.1.4. Network IP Check
5 IP Check When enabled, the camera will periodically ping the address entered into the IP Address box below.
IP Address Enter an IP Address or website URL to ping for checking connectivity.
Interval Select the time between pings to the entered IP Address or URL.
Check Failed
Check “Connection failed four times...” To enable auto rebooting if the IP address does not respond
after four attempts.
Check “Save to SD Card” to save a log file to the microSD Card when the IP Address does not respond.
Click “Apply” at the bottom-right of the page to save modified settings.