TextAlert
IV
User Manual
•
"
Status
" LED will flash once or twice to indicate sensor has been linked with the
next available zone on TA
IV
. Make sure to record details as per Table 1 above in
the SID document.
•
After 20 seconds the Status LED will return to ‘Run Mode’ (GREEN). To return the
TA
IV
to Run Mode manually, press the reset button until the status LED returns to
green. Returning the unit to ‘Run Mode’ manually, instead of waiting the 20
seconds, can help prevent unwanted signals from causing interference while linking
sensors onto TA
IV
.
•
Remove battery from the ‘linked’ sensor so that it does not accidentally interfere
while linking additional sensors onto further Zones.
•
Link additional Stay zone sensors using the above procedure.
8.2
Linking the Remotes onto TA
IV
Refer to Figure 6
•
Press and hold the reset button on the back panel of TA
IV
for 2 seconds
•
The "
Status
" LED will illuminate RED. Press any one of the buttons on the remote
(make sure you are at least 1.5 m away from the TA
IV
).
•
When a remote signal is received, the "
status
" LED will flash once to indicate that
the remote has been linked onto the next available zone on TA
IV
. Make sure to
record details as per Table 1 above in the SID document.
•
Repeat the above steps for each remote you wish to program onto the TA
IV
.
•
Unit will return to “Run Mode” automatically after 20 seconds (Status LED green).
To return the TA
IV
to Run Mode manually, press the reset button until the status
LED returns to green.
•
Note:
The remote keyfob zones on TA
IV
can be configured with customised
message programmed for each remote (see section 9.5). In this way home users
can allocate a remote to each member of the family. If the panic button is pressed
on a particular remote then SMS recipients will know immediately who has pressed
the panic button.
Note:
The TA
IV
will automatically return to “
Run Mode”
for normal operation if no
configuration event is performed within 20 seconds. This prevents the user from
accidentally leaving the unit in “
Program Mode
”. To return the TA
IV
to Run Mode
manually, press the reset button until the status LED returns to green.
8.2.1 Remote Functions
The remote buttons have fixed operations (Refer to Figure 6).
Left top is
ARM (Away) -
For when you are Away from your property.
Right top is
DISARM
Left Bottom is
ARM (Stay) –
For when you are inside your home.
Right Bottom is
PANIC
If
Away
button is pressed, the Status LED will flash ORANGE for 10 seconds (arming
delay) and then start flashing slowly to indicate
Away
armed status is in effect. The arming
delay of 10 seconds can be user adjusted from 0 – 99 seconds using the following
command:
password#37#--#
(see Table 4).
Copyright InFocus Trading 111 cc, 2009
12
