TReX User Manual v2.14 Firmware
*TREX_PIN=nnnn
where:
nnnn = 4 digit PIN number.
Typical usage:
*TREX_PIN=0000<CR>
*TREX_AN_CAL
Sets parameters used to calibrate the analog outputs and inputs. See DAC and ADC CAL Sub-
Menus for more information.
*TREX_DAC_CAL=AA,BB,CC,DD
where:
AA = DAC1 minimum count. Default 0.
BB = DAC1 maximum count. Default 1023.
CC = DAC2 minimum count. Default 0.
DD = DAC2 maximum count. Default 1023.
EE = ADC1 minimum count. Default 0.
FF = ADC1 maximum count. Default 1023.
GG = ADC2 minimum count. Default 0.
HH = ADC2 maximum count. Default 1023.
Typical usage:
*TREX_AN_CAL=0,1023,0,1023,0,1023,0,1023,
*TREX_MISMATCH
Sets parameters that control the antenna mismatch detection feature.
When an antenna is missing, damaged or mismatched, the following may be observed; The
current may increase, the RF power detected may increase/decrease through reflection, or the
output power may be low. Should any of these be detected, the mismatch output can be
configured to operate.
*TREX_MISMATCH=AA,BB,CC,DD,MM
where:
AA = the output to operate on mismatch detection.
BB = the max forward power permitted (ADC count).
CC = the max system current permitted in mA.
© WTE Limited, 2018 – Christchurch New Zealand
Page 81 of 158
