WINYCAM HX200, Руководство пользователя

Страница: 30 / 32

29
WINYCAM HX200
23. FAQ
Precaution before use
1. Please check for any defect on the product before installation.
The Company shall not take responsibility for any cost or
expense incurred as a result of the failure to check before
installation.
2. If installation was held at a service center other than those
designated by the Company, the Company shall not take a
responsibility for cost or expense charged at such center.
3. If the constant power protect function is set ‘OFF’, monitoring
during parking will be performed only for a certain period of time.
If the vehicle battery voltage is lowered for self-protection, power
to the device may be disconnected even in the Parking Mode
disabling the recording.
4. The Micro SD card is a consumable. Use of an aged SD card may
cause error. Please replace on a regular basis.
5. When a vehicle accident occurred, turn off power of the product
immediately, remove the SD card and save the accident file on your
PC. If the file is deleted due to the times away, the Company shall
not take responsible.
1. Power is not turned on.
※ Check once again if the power cable is properly connected. If the problem is not solved, please contact manufacture.
2. The map is not shown when a video is played on a PC original viewer program.
※ Check your Internet connection. Check if your Internet Explorer is v7.0 or higher.
3. Power is connected, but LED is not lightning.
※ Check if the power cable is connected properly. Then if still LED dose not lightning, the product or the SD card may be
defective. Please contact manufacture.
4. GPS signal dose not recognize. (GPS is sold separately.)
※ GPS signal reception may be interrupted temporarily depending on the environment and locations. Drive your vehicle
to other location where GPS signal reception is abled. Please wait 3-5 minutes in the GPS signal reception area.
If the signal still dose not recognized, please contact manufacture
5. The product does not recognize the SD card.
※ Remove the SD card from product after power OFF, and check for any foreign material or abnormality around the
connecting terminal. Format the SD card and try again. If the SD card is old, please replace to a new one.