Wintriss SmartPAC PRO Servo, Руководство пользователя

Страница: 133 / 228

SmartPAC PRO Servo User Manual 1147100
Chapter 5
– Program Mode
133
Figure 5-29. Ready Signal Programming Screen
NOTICE
The Ready signal you set in Program mode can be fine-tuned in Run mode after you have run the
press. See Adjusting the Ready Signal for Green Sensors , page 168, for details.
To set the Ready signal, do the following:
NOTICE
If you do not know how to use the cursor keys to set sensor Ready signal timing, see page 3-6.
1. On the Ready Signal Programming screen, set the Ready On angle on the ram angle clock, using
the Left (

) and Right (

) cursor keys.
As you press the Left (

) cursor key, the On cursor moves counterclockwise around the display,
and the On angle value decreases. When you press the Right (

) cursor key, the On cursor moves
clockwise around the display, and the On angle value increases.
The precise On angle value is displayed in the window inside the clock display.
2. Set the Ready Off angle on the ram angle clock, using the Up (

) and Down (

) cursor keys.
As you press the Up (

) cursor key, the Off cursor moves clockwise around the display, and the
Off angle increases. As you press the Down (

) cursor key, the Off cursor moves
counterclockwise around the display, and the Off angle decreases.
The precise Off angle value is displayed in the window inside the clock display.
3. When you have finished setting the Ready On and Ready Off angles, press RESET. The Sensor
Settings screen (see Figure 5-31, page 135) displays with all your sensor settings shown.
4. If you want to change any settings, refer to Viewing and Changing Sensor Settings , page 135).