Wintriss SmartPAC 2, Руководство пользователя

Страница: 442 / 604

1128600 SmartPAC 2 with WPC 2000 Integration User Manual
E-2 SmartView
Plugging in the Network Cable
1.
With SmartPAC 2 turned off, open the enclosure and plug your network (CAT5) cable
with the RJ45 connector into the Ethernet connector (J122) on the SmartPAC 2 board
(refer to Figure 2-25, page 2-51 for location).
2.
Power up the SmartPAC 2.
The green LED labeled LINK on the RJ45 connector should illuminate, indicating that the
network connection is active. If the LINK LED does not illuminate, unplug the connector
and try plugging it in again. If the LED still fails to illuminate, ask your IT department to
PING (Packet InterNet Groper) it. PING is a DOS utility used to test for network
connectivity. See
SmartView Ping Utility
, page E-15.
3.
When you are satisfied that the network connection is active, close the SmartPAC 2
enclosure.
Programming Network Settings
Enabling E-mail and SmartView and Selecting Press Type
1.
On the Main Program Menu, press the 1 and CLEAR keys simultaneously for a few
seconds until the Main Initialization Menu displays (see Figure 4-1, page 4-1).
2.
Select SETUP NETWORK to access the Network Setup Utility screen (see Figure 4-37,
page 4-57).
3.
Make sure that the E-mail and SmartView functions are both enabled. If they aren’t, press
ENTER to toggle the appropriate entry from DISABLED to ENABLED.
4.
Make sure that the Press Type is set correctly.
Setting Up E-mail
1.
Select SETUP E-MAIL on the Network Setup Utility screen. The screen that displays
(see Figure 4-38, page 4-58) provides fields in which you can enter your SMTP mail
server settings. Follow on-screen instructions to enter or edit entries.
Do not run Cat5 cable inside conduits containing AC high voltage wires. Ideally, run Cat5 cable in
a separate conduit away from sources of electrical noise.
You must have an SMTP (Simple Mail Transfer Protocol) mail server for the E-mail feature to
function properly. Contact your IT department for information about SMTP server settings and
account information. It is a good idea to have the information ready ahead of time before trying to
enter program fields.
NOTICE
NOTICE