Wintriss SmartPAC 2, Руководство пользователя, Страница: 353 / 604

SmartPAC 2 with WPC 2000 Integration User Manual 1128600
Run Mode 6-45
1.
With “TWO HAND” highlighted on the Mode Select Menu, initiate a stroke by pressing
both Run/Inch buttons, holding them until the ram reaches the Auto Carry-up Angle, then
releasing them (see
Setting the Auto Carry-up Angle
, page 4-28). The ram completes its
stroke automatically, stopping at Top-stop.
If one or both Run/Inch buttons are released before the ram reaches the Auto Carry-up
Angle, the press stops. The press will also be stopped on the downstroke if a system fault
is detected or a light curtain is blocked.
Single-stroke, One-hand Operation
Single-stroke, One-hand operation can only be used with WPC 2000 systems running
Two-hand/One-hand/Foot firmware and employing a Shadow light curtain to guard the point
of operation. To run the press in this mode, do the following:
1.
With “ONE HAND” highlighted on the Mode Select Menu, initiate a stroke by pressing
the left Run/Inch palm button, then releasing it. The ram completes its stroke
automatically, stopping at Top-stop.
The press is stopped if a system fault is detected or if a light curtain is blocked during the
downstroke.
Both Run/Inch palm buttons on each Operator Station must be pressed within 1/2 second.
Each pair of Run/Inch buttons on all Operator Stations must be pressed within 5 seconds.
Make sure that the setting on S102 switch 6 is correct for your setup (see page 4-43).
INCORRECT INSTALLATION
You must install a Shadow light curtain correctly and connect it to WPC 2000 properly in order to
run the press in Single-stroke, One-hand mode.
Failure to comply with these instructions will result in death or serious injury.
NOTICE
DANGER
!