Wintriss SmartPAC 2, Руководство пользователя

Страница: 108 / 604

1128600 SmartPAC 2 with WPC 2000 Integration User Manual
2-64 Installation
your equipment on and off. Different types of relays can be used, depending on the voltages
of your equipment and your special needs.
To mount the ProCamPAC Output Assembly and wire it to the ProCamPAC board inside the
SmartPAC 2 control, follow the instructions below. These instructions may be used with
either the 8- or 16-channel ProCamPAC board. Refer to Table 2-22 and Table 2-23,
page 2-67 for wiring connections. A wiring diagram is provided in Figure 11 at the end of the
manual.
1.
Select a convenient location for running conduit from the ProCamPAC Output Assembly
to the equipment that it will control.
2.
Mount the output enclosure, using the mounting holes on the flanges as shown in
Figure 2-31, page 2-65.
3.
Select the relays to be used with each channel. Relays should already be plugged into the
Cam Outputs board (see Figure 2-32, page 2-66), each relay labelled with its type (i.e.,
standard or solid state).
Standard relays can only be plugged into the slots labeled K301 through K305, K307,
K309, and K311, which are channels 1-8. Optional solid state relays can only be plugged
into slots labeled K306, K308, K310, and K312, which are channels 5-8.
Do not mix standard and solid state relays in channel locations 5-8. For example, if you
plug a solid state relay into channel 5 (location K306), you cannot plug a standard relay
into location K305. See Figure 2-32.
Example
Say you wish to use three standard relays and one solid state relay. You would install the three
standard relays in channels 1 through 3, and the solid state relay in channel 5, skipping the
channel 4 output for all wiring and programming.
4.
To remove a relay, pull the plastic retention clip away from the relay and pull the relay
straight out of its socket. When re-inserting the relay, make sure that the pins line up with
the socket holes, then press in firmly.
5.
Locate the 12-conductor cable(s) for wiring the ProCamPAC board (see Figure 2-30,
page 2-58 for layouts of 8- and 16-channel boards) to terminal block TB301 inside the
ProCamPAC Output enclosure. If you are wiring an 8-channel ProCamPAC, one cable is
supplied (for channels 1-8). If you are wiring a 16-channel board, two cables are supplied,
one for channels 1 through 8, the other for channels 9 through 16.
6.
Remove the appropriate connector(s) from its socket on the ProCamPAC board (TB401
for an 8-channel ProCamPAC, TB451 and TB452 for a 16-channel ProCamPAC).
Connect wires from the 12-conductor cable(s) to the pin locations on the appropriate
terminal blocks, as shown in Table 2-22, page 2-67 (for the 8-channel option) or
Table 2-22 and Table 2-23 (for the 16-channel option). See also Figure 11 at the end of
the manual.