Quick start
iModuleShutter US
Technical specs
Normal operating
voltage
AC110V
~
60Hz
Figure 1-4
Maximum load
0.9HP
Frequency range
908.42MHz
Wireless
Range
Up to 30m line of
sight
Basic Operations
-The iModuleShutter can be remotely controlled.
-The iModuleShutter can be add/remove from the network by continuously switch on and
switch off the external switch 3 times quickly.
-The iModuleShutter’s indicator light will indicate the status of the iModuleShutter.
Mounting
1. Turn OFF power by switching off the circuit breaker or removing the fuse and test that power
is off before wiring!
2. Ensure iModuleShutter capacity matches the load requirements.
3. Wall Installation: Connect it with your existing external switch,
default is one push button
switch
. Please see below Wiring Diagrams &
Configuration Parameters.
4. Reapply power to the circuit at fuse box or circuit breaker to test the system carefully, if the
indicator light on iModuleShutter blinks 30 seconds and then keep breathing, it means the
installation is in good condition.
5. Turn OFF the power again.
6. For Wall Installation: Insert your external switch together with iModuleShutter into switch box
being careful not to pinch or crush wires, and secure it with screws. Reapply power to the
circuit at fuse box or circuit breaker.
Maximum load:
AC110V
~
60Hz , 0.9HP
Wall Installation Wiring Diagram, connect with external switch: (see Figure 2-4, 3-4, 4-4)
Please note:
A 3A external fuse before the red wire Live of the iModuleShutter module
must be installed
in the installation for protect the iModuleShutter switch
overload. (see Figure 2-4, 3-4) Red wire refers to Live, blue wire refers to Neutral,
and black wire refers to connecting with switch.