Winterthur Gas X40-B, Руководство по обслуживанию

Страница: 63 / 495

Maintenance
0380--1/A1
Winterthur Gas & Diesel Ltd.
1/ 9
Maintenance Schedule
Inspection and Overhaul Intervals (Guidelines)
Group Component Applicable Maintenance Intervals
0
System oil -- Laboratory analysis 3000 Operation hours
(Op. h )
Fuel and
lubricating oil
filters -- Do a check of the filter elements for white metal
particles (clean or replace the filters as
necessary). Follow manufacturer’s instruction
3000
Cooling water -- Find the quality and concentration of inhibitor and
pH value
(read the data in the documentation of the
inhibitor manufacturer)
weekly
1
1112--1 Bedplate -- Do a pre-tension check of the of foundation bolts
first time after 1500 Op. H
-- Do a check of the rubber gasket condition in the
vertical oil drain dump (see SPC 9722). First time
as soon as possible after ship is supplied)
-- Estimated service life: bedplate foundation bolts
12000
30000 (replacement
recommended)
Engine lifetime
Crankcase -- Visual examination
100 Op. h after maintenance
1500 to 3000
1132--2 Main bearing -- Bearing shell inspection is only necessary if the
bearing clearances, crankshaft deflection. Wire
check oil analysis or crankcase inspection shows
too much damage or worn areas
-- Do a check of the bearing clearances (refer to
0330--1 Group 11321 )
-- Use wire to do a check of the bearing edge
-- Estimated service life: Main bearing shell
At indications of too
much damage or worn
areas
6000
6000
> 100000
1203--1 Thrust bearing -- Do a check of the axial and vertical clearances 6000
-- Make sure that the bottom drain is not blocked 6000 to 8000
1224--1 -- Inspection of the thrust bearing pads is only
necessary if the bearing clearance, oil analysis or
crankcase inspection shows damage or worn
parts
-- Estimated service life: Thrust bearing
At indications of too
much damage or worn
parts
Engine lifetime (replace
if necessary)
2020