SBC35-427/Software Description
v1.0
www.winsystems.com
Page 27
5.2
Hardware
Jumpering pins 1-2 on jumper JP1 enables you to reset the BIOS CMOS
settings to factory defaults. The BIOS reads this pin during system boot
and forces the settings to reset if the pin is at ground.
To reset the BIOS CMOS parameters to factory defaults using JP1:
1. Remove power from the board.
2. Place a jumper across 1-2.
3. Apply power to the board, and let it boot into the BIOS.
4. Power off the board, and remove the jumper at 1-2.
6.
Software Description
This section describes the AMI BIOS components to be used in the
implementation of the SBC35-427 BIOS firmware.
6.1
Software Design Specification: UEFI Operating System Support
The BIOS supports booting the following UEFI-compliant operating
systems:
• Windows 10 x64, IoT Core, and Professional
• Linux x64
• Most x86 operating systems
6.2
Software Design Specification: Legacy Operating System Support
The BIOS supports booting the following legacy OS capabilities:
• MS-DOS 6
• Compatibility support module (CSM)
• Legacy boot support
• Legacy option ROM support
6.3
Software Design Specification: Boot Device Configuration
The BIOS supports booting an OS from the following devices:
• USB mass storage device
• Serial ATA (SATA) device
• Network boot - PXE
• eMMC
• M.2 mass storage device
