WinSystems PPC65BP-1 Series, Руководство по эксплуатации продукта

Страница: 18 / 63

PPC65BP-1x/Setup and Installation
v1.0 www.winsystems.com Page 18
7.5 Connecting Power to J16
To connect power through the 3-pin terminal block:
1. Plug the 3-pin female terminal block to J16 securing with the two
captive screws.
2. Using the following the pin definition in the table below, install the
power supply wiring and secure with connector screw.
– Use AWG 22-14 wire
– Supply voltage between 12 V DC and 24 V DC
– Make connections according to the following table:
7.6 Connecting Components
The PPC65BP-1x provides edge connectors for common external
connections, and also internal connections to components on the board
(see “Touch Screen External Control, Connector, and Indicator Locations”
on page 10).
1. Connect an Ethernet cable to Gigabit Ethernet (connects to J13/J14, as
applicable).
Pin Description
1 Ground (Earth)
2 Voltage in negative (Vin-)
3 Voltage in (Vin+)
3-pin terminal block