SECTION 6 –
ELECTRICAL
6-2
be used is designed to mate with the prongs of the
power cord plug, the electrical connection can be
expected to carry rated load.
Connecting The Power Cord
To connect to an external source, remove the
cord from the utility compartment and plug it into
a suitable 50-amp power receptacle to provide
external power to the coach and converter/
charger system.
NOTE: Some parks do not have 50-amp service
available, so you will need to connect to
a standard 30-amp service pole using an
adapter.
A flip-down hatch lets you route the power
cord out the bottom of the compartment so you
can close the compartment door while the power
cord is connected.
1. Flip the hatch downward.
2. Swivel the cover section aside to reveal cord
notch.
3. Route the cord through the notch and flip the
hatch back up into place and close the
compartment door.
NOTE: Always keep service access passage
closed while utility connection is not in
use.
Park Fuses or Breakers
Most campgrounds are equipped with a fuse
or circuit breaker at the receptacle (which we
recommend shutting off before engaging or
disengaging the power cord.) This protects the
park’s wiring, as well as the power cord on your
vehicle from electrical damage. If electrical
power fails, contact the park attendants and have
them check the fuse or breaker for your supply
receptacle.
INVERTER UNIT – 1000W
–If Equipped
The inverter unit is located on the wall of the
utility compartment.
50 Amp.
Power Receptacle
30 Amp Receptacle
