3-11
SECTION 3 –
DRIVING YOUR MOTOR HOME
FRONT SERVICE ACCESS
(HOOD)
The Hood Panel can be opened for access to
service items such as the engine oil dipstick, oil
fill, radiator fill, power steering reservoir, and
windshield washer fluid reservoir.
The Hood Latch is located behind the bottom
edge of the Hood Panel near the center of the
grille.
To Open Hood Panel
•
Squeeze or Pull the Hood Latch toward the
Hood Panel to release the latch.
•
Pull the Hood Panel outward slightly and raise
up into open position.
To Close Hood Panel
•
Pull Hood Panel DOWN and swing IN.
•
Press top edge of Hood Panel in firmly with
palms of hands to ensure proper latching.
ENGINE ACCESS – INTERIOR
Front Engine Cover
•
To remove the engine cover,
insert the
supplied hex wrench into the hole in the top
center or the front edge of the engine cover,
depending on model.
•
Turn the hex wrench to the left (counter-
clockwise) to unlatch.
NOTE: On some models there may also be
screws to remove at the lower front
corners. See following photo.
•
Remove cover and set aside.
Hood Latch
(Squeeze or Pull toward Hood Panel
and raise up into open position)
• Insert hex wrench into the hole on the top
center of the engine cover (as shown) or
the front edge of engine cover to unlatch
-Typical View
• Remove screws on both sides of engine cover
-Typical View
