10-9
SECTION 10 –
SLIDEOUT ROOMS AND LEVELING
Further Information
See the Slideout Room operating guide
included in your InfoCase for further instructions
and troubleshooting information.
SLIDEOUT EMERGENCY
RETRACTION - BEDROOM
-If Equipped
If the slideout mechanism is malfunctioning
and the room will not retract using the interior
control switch, you may need to access the
motor/gear assembly and manually crank the
room in to the travel position.
The rear bedroom slideout has a motor/
gearbox unit, which is located underneath the
bed. Remove panel to access as shown in the
following photo (if equipped).
Crank-In Procedure
1. Disengage the motor brake, which appears as
a flat “square” protrusion on the protective
boot at the end of the motor. Move the brake
lever slightly – about 1/8 turn counter-
clockwise (to left when facing end of motor).
2. Disconnect the motor power lead from the
wiring harness.
3. Use a 3/4” socket and ratchet wrench on the
motor gearbox shaft to crank the room in.
4. Crank the room until it is just “snugged up.”
Do not overcrank or you could damage the
gear assembly.
5. While maintaining pressure on ratchet
wrenches, re-engage the motor brake by
moving lever clockwise slightly (to right
when facing end of motor).
6. Reconnect motor power lead to wiring
harness.
7. Reinstall access panel (if equipped) and lower
bed board.
8. Fasten slideout room travel latching device (if
equipped) inside the coach before driving the
vehicle.
9. See your dealer for service of the slideout
mechanism before using again.
Further Information
See the slideout manufacturer’s user guide
provided in your InfoCase for further instructions
and troubleshooting information.
Removable Panel (if equipped)
(Located underneath bed)
* Lift bed board to access
-Typical View
Rear Slideout Motor/Gearbox Unit
(Located underneath rear bed)
-Typical View
3) Use 3/4”socket
on gearbox shaft to
crank room in
2) Disconnect motor
power lead from
wiring harness
1) Lift tab inside
protrusion on boot to
disengage motor brake
