SECTION 5 –
ELECTRICAL
5-2
The power cord is designed to ground the
electrical system through the receptacle. It is also
designed to carry the amperage output of most
campground outlets. If the electrical receptacle to
be used is designed to mate with the prongs of the
power cord plug, the electrical connection can be
expected to carry rated load.
Park Fuses or Breakers
Most campgrounds are equipped with a fuse
or circuit breaker at the receptacle (which we
recommend shutting off before engaging or
disengaging the power cord.) This protects the
park’s wiring, as well as the power cord on your
vehicle from electrical damage. If electrical
power fails, contact the park attendants and have
them check the fuse or breaker for your supply
receptacle.
INVERTER/CHARGER UNIT –
2000W (PURE SINE WAVE)
–If Equipped
The 2000-watt inverter/charger has an AC
input circuit breaker to protect the inverter/
charger from overloads. The inverter/charger
also has “built in” features that protect the system
from abnormal conditions. See the inverter/
charger information included in your InfoCase
for a complete explanation of the system and
operating instructions.
NOTE: The inverter is not intended for steady
use while “dry camping”. Batteries will
deplete quickly with use of the inverter.
The inverter is intended for limited, short
term power usage when not connected to
shoreline or generator power.
The inverter can also be used while
driving the motorhome because the
engine alternator will charge the
batteries while driving.
The inverter/charger unit is accessible through
the driver’s side battery access compartment.
WARNING
This connection is for 110/125 Volt AC,
60 Hz 30 Ampere supply.
Do not exceed circuit rating. Exceeding
the circuit rating may cause a fire and
result in death or serious injury.
WARNING
Service inlet access must be closed when
utility connections are not in use.
30 Amp Receptacle
Detachable Power Cord
-Typical View
