12-9
SECTION 12 –
MISCELLANEOUS
Vertical Slider Windows
Vertical windows have spring-loaded catches
on both sides of the window that pop out to hold
the window in its fully raised position. Press the
catches outward toward the frames while
lowering the window.
POWER ROOF VENTILATOR –
GALLEY
–If Equipped
The 3-speed turbine vent is controlled by a
switch on the wall to raise or lower the dome.
The turbine fan will start automatically as the
vent is raised, and stop as the vent is lowered.
A thermostat near the OnePlace
®
monitor
panel can also be set to automatically open and
close the vent at a selected temperature.
To Operate Ceiling Ventilator
1. Press the wall switch to raise the dome about
3" or more to allow the turbine fan to operate.
(
A built-in safety switch will not let the fan
motor run unless the dome is partially open
).
2. The turbine fan will start automatically as the
vent dome is raised and stop as the vent dome
is lowered and closed. (
Fan Power switch
must be ON and Fan Speed knob in a position
other than 0-Off
.)
3. Turn the Fan Speed knob to the desired level
(1-Low, 2-Med, 3-Hi).
4. Open a window or door to provide airflow.
Direction of airflow is determined by which
window or door is opened.
NOTE: For best results, close all other roof
vents, windows, and doors, then open
one (1) window the farthest distance
from the roof ventilator. The fan speed
selector on the ventilator allows you to
control the amount of circulation you
need at any time.
5. If you want the vent dome raised without the
fan running, turn Off either the Fan Power
switch or Fan Speed knob (0-Off ).
Vertical Window Catches
Power Ventilator
Fan Speed
Selector
Fuse
Fan Power
Switch
Dome Crank
