6-7
SECTION 6
ELECTRICAL
GENERATOR SLIDE OUT
SERVICE TRAY
The generator service tray can be extended
and retracted on a slideout frame mechanism.
To extend generator frame for
service:
1. Pull the travel-locking pin from the slide rail.
It is located on the driver side of the generator
and can be seen by looking down just inside of
the “hood” panel opening as indicated by the
arrow in the photo below. The pin is tethered
to the rail assembly by a small cable.
2. Pull the slide frame outward until generator
frame is fully extended.
3. After storing the generator, be sure to reinsert
the travel pin into the slide rail frame. You
may need to move the generator and grille
panel in or out slightly by hand to align the
holes properly to insert the pin.
12-VOLT DC SYSTEM
The DC voltage system consists of the
automotive batteries and the 12-volt coach
auxiliary batteries.
BATTERY INFORMATION
Chassis Batteries
The chassis batteries operate the engine starter
and all automotive accessories and controls
found on the instrument panel. The leveling
jacks, slideout room system and the electric step
are also connected to the chassis battery.
A battery monitor device called Trik-L-Start
will help maintain the chassis battery charge
anytime the coach is plugged into 120-volt shore
power and the battery disconnect switch is in the
“On” position.
WARNING
Never check generator oil level while
generator engine is running.
(See also Automatic Generator Start
warning)
Travel Pin - see arrow
Viewed looking downward at left side of generator
through front “hood” panel opening.
WARNING
Make sure travel pin is in place to secure
generator before driving after generator
service or maintenance. Failure to do so
may allow the generator to extend
unexpectedly during sudden brake
application or other rapid deceleration.
