4-15
SECTION 4
APPLIANCES & SYSTEMS
To Open During a Dry Cycle:
1. Advance the Program selector to 'Reset' (the
'Status/Door Lock' LED will blink quickly to
indicate that the cycle has stopped, but the
door is STILL LOCKED)
2. When the 'Status/Door Lock' LED blinks
SLOWLY (takes 1-2 minutes), you can open
the door.
IMPORTANT! Once a wash cycle is
underway, the washer-dryer door will LOCK for
the duration of the cycle and will STAY LOCKED
for up to 2 minutes after the cycle ends. DO NOT
attempt to open the door unless the 'STATUS/
DOOR LOCK' LED is BLINKING SLOWLY!
Water Supply Faucets
The washing machine water supply faucets
are located inside the cabinet door above the
machine. Always turn supply faucets off when
not using washing machine to avoid possible
water leaks if a hose or hose gasket should fail.
See Winterization Procedure in Plumbing
section.
DISHWASHER
(Drawer Style)
–If Equipped
Lock Feature
The Dish Drawer must be programmed to the
‘Closed Drawer’ mode to keep the drawer locked
while driving.
1. Press the power button (left side of touch
panel).
2. Open the drawer, then press the ECO button
on the inside of the drawer and the Lock
button (right side of touch panel) at the same
time until you hear one long beep.
3. Press the start/pause button (center of touch
panel) 3 times; the light above the button will
be red.
4. Press the Lock button (right side of touch
panel) to turn the “Closed Drawer” feature on.
The lights on display panel inside of the
drawer will light up.
5. Press the power button (left on touch panel)
the unit is set.
Water Supply Faucets -typical
Power
Button
Lock
Button
Start/Pause
Button
