SECTION 3 –
DRIVING YOUR MOTORHOME
3-32
Attach the hub cover wrench to the hub
cover.
•
Align the hex of the wrench opening with the
hex of the hub cover center nut and move
wrench inward until the nut surface is
outboard of the wrench.
Driver Side (left hand thread)
•
To Remove turn clockwise.
•
To Install turn counter-clockwise.
Passenger Side (right hand thread)
•
To Remove turn counter-clockwise.
•
To Install turn clockwise.
Further Information
Contact Freightliner
®
Custom Chassis for
more information: 1-800-FTL-HELP (1-800-
385-4357).
SUSPENSION ALIGNMENT
AND TIRE BALANCE
The front suspension and steering system of
this vehicle was factory aligned using highly
accurate equipment prior to delivery to the
dealership. However, alignment should be
checked and adjusted after you have fully loaded
the motorhome according to your personal needs.
Thereafter, the alignment should be periodically
inspected to help prevent uneven tire wear.
Any excessive or abnormal tire wear may
indicate worn or misaligned suspension or
steering, unbalanced tire, or other tire/suspension
problem.
Alignment can be affected by worn steering/
suspension parts or by incidents which happen
during driving, such as hitting a curb, pothole, or
railroad track, etc. Improper alignment can cause
tires to roll at an angle and wear unevenly. It may
also cause the vehicle to “pull” to the right or left.
Have your dealer inspect your vehicle’s
suspension and steering components periodically
for misalignment or wear.
Out-of-balance tires will not roll smoothly and
can lead to vibrations and uneven tread wear,
such as cupping and flat spots. Tires may need to
be balanced if uneven wear is detected or if ride
comfort decreases noticeably.
Further Information
Refer to the chassis manual provided in your
InfoCase for further information.
LIGHTS
All exterior lights should be checked for
proper operation each time the vehicle is
prepared for a trip. Any bulbs which fail to light
should be checked and replaced, when necessary,
with a new bulb of the same size. A failure of
more than one light, such as both taillights not
operating, may indicate a burned out fuse. Check
fuse and replace with one of the same rating
when necessary. If a fuse is not the cause of the
problem, the wiring system should be checked
immediately by an authorized service center.
Further Information
Refer to the chassis manual in your InfoCase
for further information.
