12-7
SECTION 12 –
MISCELLANEOUS
•
FLAME:
Each time the flame button is
pressed, the intensity of the flame decreases.
There are (6) brightness levels you can cycle
through and the OFF setting.
•
HEATER:
Turns the heater function ON and
OFF. The thermostat is adjustable by 2°F or
1°C increments by pressing the up or down
arrows.
•
SIDELIGHTS:
Press the sidelights button to
change the sidelight between (4) settings:
amber, blue, blue/amber, auto-cycling, and
off.
•
UPLIGHTS:
Press the uplights button to
change the uplight between (4) settings:
white, blue, white/blue, auto-cycling, and off.
•
TIMER:
Press the TIMER button to cycle
through the (10) timer settings (30 minutes, 1
Hour to 9 Hours) and the OFF setting.
Control Panel
NOTE: Holding the POWER button on the
control panel for ten seconds will disable
the heater function.
Further Information
Refer to the Fireplace user guide provided in
your InfoCase for complete operating and
maintenance instructions, as well as safety
precautions.
FIREPLACE
–If Equipped
NOTE: The fireplace can be operated by either
the remote control or the control panel.
Remote Operation
•
POWER:
The POWER button supplies
power to all the functions of the fireplace. The
POWER button will put the insert in standby
mode. This will turn off all functions at once
but will hold the settings in the memory. By
pressing the POWER button again the unit
will turn on at the same settings.
•
FLAME:
Each time the flame button is
pressed, the intensity of the flame decreases.
There are (6) brightness levels you can cycle
through and the OFF setting.
• Up/Down
buttons
• Timer
• Heater
• Flame
• Power
• Sidelights
• Uplights
Fireplace Control Panel
(Located on right side of fireplace)
-Typical View
• Power
• Flame
• Heater
• Backlight
Fireplace Remote Control
(Located inside InfoCase)
• Timer
