SECTION 10 –
SLIDEOUT ROOMS AND LEVELING
10-10
•
Crank the room until it is just “snugged up.”
Do not overcrank or you could damage the
gear assembly.
•
While maintaining pressure on ratchet
wrenches, re-engage the motor brake by
moving lever clockwise slightly (to right
when facing end of motor).
•
Reconnect motor power lead to wiring
harness.
•
Fasten slideout room travel latching device (if
equipped) inside the coach before driving the
vehicle.
•
See your dealer for service of the slideout
mechanism before using again.
Further Information
See the slideout manufacturer’s user guide
provided in your InfoCase for further instructions
and troubleshooting information.
GENERAL SLIDEOUT CARE
•
Keep slideout room seals clean.
•
Clean the floors inside the coach before
retracting the slideout room to avoid floor
scratches or carpet pile snags.
•
Wipe outer slideout room seals occasionally
with talc or 303 brand protectant for smooth,
quiet operation.
•
See your authorized dealer for regular
maintenance and service of the slideout
mechanism.
Slideout Room Seal Care and
Maintenance
While most household cleaners work well for
cleaning slideout room seals, certain chemical
agents may cause the seals to degrade. Typically,
409
®
and Lysol
®
type products work well. Use a
product, such as Armor All
®
to keep seals soft.
In addition, certain caulks and sealers may
include chemicals that may adversely effect the
performance of the seals. See your authorized
dealer for caulks and sealers recommended for
your coach.
LEVELING SYSTEM
(HYDRAULIC)
–If Equipped
The Hydraulic Leveling System makes
selecting a parking site easier and faster by
reducing the effect of uneven ground.
Hydraulic jacks raise the affected low corners
of the coach to make leveling “set up” faster and
easier for you.
The Hydraulic Leveling System Control Panel
is located on the driver side trim panel.
See the Leveling System Operation Guide
provided in your InfoCase for complete
operating instructions.
It also contains
additional precautions, technical information,
and instructions for manual operation if a system
failure occurs.
Rear Slideout Motor/Gearbox Unit
(Located underneath bed)
-Typical View
3) Use 3/4”socket
on gearbox shaft to
crank room in
2) Disconnect motor
power lead from
wiring harness
1) Lift tab inside
protrusion on boot to
disengage motor brake
