3-11
SECTION 3 –
DRIVING YOUR MOTOR HOME
NOTE: On some models there may also be
screws to remove at the lower front
corners. See following photo.
•
Lift the rear end of the cover upward and slide
rearward, then pull the cover from the
opening.
NOTE: On some models the beverage tray (if
equipped) may need to be removed to
provide additional clearance to extract
the engine cover.
If the beverage tray has a drawer, it must
be removed to expose the fasteners that
hold the tray to the motor cover.
•
To reinstall the engine cover
, position the
front end of the cover first, then lower the rear
end. It is important to be sure the front edge is
pushed completely forward to the radiator
cover to ensure an air-tight seal.
•
Press the rear end of the cover down and turn
the hex wrench to the right (clockwise) until
the latch pulls the cover downward and stops.
•
Reinstall the two side screws (if equipped).
ENGINE COOLING SYSTEM
Do not remove the radiator cap while engine
and radiator are still hot. Always check coolant
level visually at the see-through coolant
reservoir.
NOTE: Your chassis engine cooling system is
filled with special extended-life coolant
that is not the same as common anti-
freeze available at retail outlets.
The coolant system MUST be refilled or
topped up with the same type of coolant
as equipped to maintain the special long-
life properties.
Further Information
Refer to the chassis manual in your InfoCase
for information and precautions on filling,
servicing, and checking the fluid level.
• Insert hex wrench into the hole on the top
center of the engine cover (as shown) or
the front edge of engine cover to unlatch
-Typical View
• Remove screws on both sides of engine cover
-Typical View
-Typical View
NOTICE
When refilling the coolant system of a
vehicle equipped with a rear auxiliary
automotive heater and motoraid water
heater, be sure to allow for additional
coolant capacity of the heater and its
supply and return hoses.
