SECTION 11 –
MAINTENANCE AND STORAGE
11-10
9. After flushing fresh waterlines, install a new
water filter cartridge on the galley sink water
filter and/or full-coach water filteration
system (if equipped). See appropriate filter
installation instructions in Plumbing section.
NOTE: Always purge a new filter with clean
running water before using. See filter
manufacturer’s directions included with
the filter cartridge.
10. Check the toilet for proper operation.
11. Add water to the holding tank using the toilet
flush pedal and galley sink faucet. Check to be
sure dump valves seal tightly.
12. Check around all appliances for obstructions
and ensure that all vent openings are clear.
13. Start refrigerator and check for proper
cooling.
14. Clean wall and counter surfaces.
15. Replace batteries, if necessary, and check out
electrical system to make sure all lights and
electrical components operate.
16. Check tires for proper cold inflation pressure.
See
Vehicle Certification Label
in
Introduction section.
17. After washing accumulated winter grime
from the vehicle, it is important to carefully
inspect the seams and sealants for separation
or cracks that may have appeared around the
window frames, vents, and any other joints.
See
Sealants – Inspection and General
Information
at the beginning of this section.
Resealing is quite simple and the material is
quickly and easily applied. Appropriate
compounds are available from your dealer.
See the
Sealants – Recommended Application
page in the Supplement Manual provided in
your InfoCase.
Also inspect weather seals around doors, etc.,
and if necessary, have a dealer replace
immediately.
CHASSIS SERVICE AND
MAINTENANCE
Consult the appropriate sections in your
chassis manual for specific information
regarding operating safety, service
recommendations, and maintenance schedules
for the chassis section of your motor home.
