SECTION 3 –
DRIVING YOUR MOTOR HOME
3-8
The rearview camera monitor system lets you
see what is directly behind your coach for
maneuvering assistance and safety. Optional
sideview cameras* also allow you to see what is
beside you before turning or changing lanes.
The monitor screen “wakes up” automatically
when transmission is shifted into reverse. A
microphone built into the rear camera lets you
hear warning sounds or verbal directions from an
assistant.
The monitor screen also doubles as a
secondary display panel for the optional GPS
system, if desired.
Basic Operating Instructions
Sideview Cameras* (if equipped)
The optional sideview cameras activate with the
corresponding turn signals and replace the rear
camera view on the monitor until the turn is
completed or the signal lever is canceled
manually.
Further Information
See the rearview monitor manufacturer’s
complete operating information in your
InfoCase.
ELECTRONIC COMPASS AND
OUTSIDE THERMOMETER
Further Information
See the compass manufacturer’s guide in your
InfoCase for detailed operating instructions,
calibration, specifications, and other information.
POWER SUNVISORS
–If Equipped
The powered sunvisors are controlled by
switches on the driver and passenger armrest
panels.
•
Press and hold the desired switch DOWN to
extend or UP to retract, then release at the
desired position.
•
Driver side switches allow the driver full
control of all visors.
•
Passenger side switch controls only the
passenger side visor.
NOTE: Do not position visors where they will
impair the driver’s forward vision or side
mirror views.
Power
- In STANDBY position, the monitor is
“asleep” and will “wake up” when the transmission
is shifted into Reverse.
The ON position activates the monitor for rear
viewing while driving or parked. Key must be on.
Input Camera/Aux -
Press to switch between
viewing Camera(s) or Aux GPS display (optional
)
on
monitor.
Night/Day -
Press to adjust contrast and brightness
for nighttime and daytime lighting conditions. After
making adjustments, button is used to switch
between settings.
•
F/C Button -
Press to switch between
Fahrenheit and Celsius temperature degree
scales.
When display is off, press and hold to check
temperature.
•
Mode Button -
Press to “page through”
functions: Compass > Thermometer >
Calibration.
