SECTION 8 –
ENTERTAINMENT
8-8
Raising Antenna to Operating Position
Turn elevating crank clockwise in “UP”
direction until some resistance to turning is noted
(about 13 turns). Antenna is now in operating
position.
Turn amplifier power switch “ON” to receive TV
signal.
Rotating Antenna for Best Picture
Make sure antenna is in the “UP” position.
Pull down on directional handle using both hands
until it disengages ceiling plate and rotate for best
picture and sound on TV set.
Lowering Antenna to Travel Position
Rotate antenna until pointer on directional
handle aligns with pointer on ceiling plate.
Turn elevating crank (counter-clockwise) in
“DOWN” direction until resistance is noted
(about 13 turns). Antenna is now locked in travel
position. Turn amplifier power switch “OFF”.
TV SIGNAL AMPLIFIER
The TV signal amplifier is built into the
antenna and can be turned on or off with a power
switch on the video selection system in the video
center cabinet above the driver and passenger
seats or entertainment center cabinet.
A red indicator light will glow when the
switch is on and the signal amplifier is active.
Checking Amplifier Performance
The TV signals available to an RV are entirely
dependent on its location in relation to the
transmitter (tower). Signals may vary from
strong to no usable signal at all. We recommend
that the TV system be checked out in an area
known to have good TV reception.
To check the antenna amplifier, raise the
antenna, select a TV channel and rotate the
antenna for best picture. Then turn off the
amplifier power switch. If the antenna amplifier
WARNING
Never allow the antenna to touch
electrical power lines or any other
electrical wires.
CAUTION
Always align directional handle to
“DOWN” position before lowering.
Never partially raise or lower antenna.
Antenna must be raised fully up into
operating position or lowered fully down
into travel position.
TV Signal Amplifier Switch on
Video Selection System
(Typical View)
