SECTION 3 –
DRIVING YOUR MOTOR HOME
3-16
CB RADIO POWER WIRING
Your coach is pre-wired for CB radio power
connection. The wires are located beneath the
dash to the left of the steering wheel.
Look for a pair of wires, yellow (+) and white
(-), with connectors and flag labels, suspended
from the wiring harness.
FUEL SELECTION – DIESEL
ENGINE
–If Equipped
Refer to your chassis manual for the
manufacturer's recommendations on proper fuel
selection (ULSD fuel only).
Winter Fuel Waxing and Anti-Gel
Additives
In sub-freezing temperatures, #2 diesel fuel
can form small wax crystals that become trapped
in the fuel filter and block the fuel flow to the
engine, causing it to stall out. At sub-zero
temperatures, the fuel can congeal and turn
“slushy”. If this happens, the only remedy is to
have the vehicle towed into a heated facility to
allow the fuel to warm up and become fully
liquid again.
During winter time, most truck stops and
reputable filling stations have winter blend diesel
fuels available that are less susceptible to waxing.
There are also commercially available
products, typically called anti-gel additives, to
add to diesel fuel while filling the tank to inhibit
wax formation in freezing temperatures.
Consult your chassis manual or diesel engine
guide for more information on fuel requirements
and additives.
FILLING THE FUEL TANK –
DIESEL ENGINE
–If Equipped
Diesel fuel, especially #2 grade, can foam up
while being pumped into the tank. Sometimes
this foam can cause the pump nozzle to shut off
before the tank is actually full. Allow the foam to
settle then resume filling at a slower flow rate
until the tank is full.
STARTING AND STOPPING
DIESEL ENGINE
–If Equipped
Refer to your chassis manual for the
manufacturer's recommendations on starting and
stopping the engine.
See also “Engine Block Heater” in this
section.
Do not attempt to start the vehicle by hot-
wiring.
Idling Diesel Engine
CB Power Wires
(in plastic sheath)
typical view - your coach
may differ slightly
CAUTION
Do not operate engine at low idle for long
periods with engine coolant temperature
below the minimum specification in your
diesel engine manual. This can result in
the following:
•
Fuel dilution of the lubricating oil
•
Carbon build up in the cylinder
•
Cylinder head valve sticking
•
Reduced performance
