10-1
5 - DASH / AUT
O
SECTION 10 – SLIDEOUT ROOMS AND LEVELING
SLIDEOUT ROOM TRAVEL
LOCKS
–If Equipped
Some models are equipped with electric
powered travel locks on slideout rooms to restrict
movement of the slideout room while the vehicle
is in motion. The room will not extend until the
lock is fully released.
Slideout Lock switches are located near the
slideout control switches on the dash or on a wall
in an area near the slideout room.
NOTE: Be sure locks are fully released before
attempting to extend or retract room.
If the latch mechanisms are protruding
more than 1/4”, the room will not extend
or retract and the slideout hydraulic
pump will run in idle/bypass mode.
To Release:
•
Press and hold the ‘unlock’ side of the
Slideout Lock switch for about 7 seconds.
(You may be able to hear the lock motor sound
stop.)
To Lock:
•
Press and hold the ‘lock’ side of the Slideout
Lock switch for about 7 seconds. (You may be
able to hear the lock motor sound stop.)
SLIDEOUT ROOM KEYLOCK
–If Equipped
A master slideout room keylock is located
near the power switch for the front slideout room.
This keylock must be turned on to provide power
to the slideout control switches.
SLIDEOUT ROOM OPERATION
– HYDRAULIC
CAUTION
Release Slideout Lock before attempting
to extend slideout room. The room will not
extend until the lock is fully released.
Fasten Slideout Lock before driving
vehicle. See following instructions.
Slideout Room Locks - Typical
Your model may be equipped with
one or more types
WARNING
Your motor home may have more than
one slideout room. Understand which
switch operates which slideout room prior
to operation. Make sure all slideout rooms
are clear of people who could be harmed
or obstacles that could cause damage
prior to operating any slideout rooms.
Slideout Room Keylock
