16
15" ATEX Panel PC User Manual
2.3 Connectors
2.3.1 Wiring Requirements
The following common safety precautions should be observed before installing any electronic
device:
•
Strive to use separate, non-intersecting paths to route power and networking wires. If power
wiring and device wiring paths must cross make sure the wires are perpendicular at the
intersection point.
•
Keep the wires separated according to interface. The rule of thumb is that wiring that shares
similar electrical characteristics may be bundled together.
•
Do not bundle input wiring with output wiring. Keep them separate.
•
When necessary, it is strongly advised that you label wiring to all devices in the system.
CAUTION/ATTENTION
•
Do not run signal or communication wiring and power wiring in the same conduit. To
avoid interference, wires with different signal characteristics (i.e., different interfaces)
should be routed separately.
•
Be sure to disconnect the power cord before installing and/or wiring your device.
•
Verify the maximum possible current for each wire gauge, especially for the power
cords. Observe all electrical codes dictating the maximum current allowable for each
wire gauge.
•
If the current goes above the maximum ratings (80 W), the wiring could overheat,
causing serious damage to your equipment.
•
Be careful when handling the unit. When the unit is plugged in, the internal
components generate a lot of heat which may lead the outer casing too hot to touch.