WinGD X92-B, Руководство по эксплуатации

Страница: 80 / 460

4.7 Starting air system
The starting air system turns the crankshaft before the usual combustion cycle of the engine is
started.
For the schematic diagrams, refer to section 13.1 Schematic diagrams - general .
The starting air system has the engine connections as interface to the plant as follows (in Figure
4-7 marked with a circle):
•
Connection point 40 (starting air pipe inlet)
•
Connection point 41 (venting crankcase outlet)
• Connection point 45 (control air supply inlet).
The starting air system has the parts that follow:
• Starting air shut-off valve
The starting air shut-off valve (009) supplies the starting air supply pipe with starting air.
The starting air shut-off valve has three positions:
○
CLOSED
○
AUTO
○
OPEN.
• Starting air supply pipe
The starting air supply pipe (007) supplies the starting valves of each cylinder with starting
air. The starting air supply pipe has a safety valve (003) and two drain valves (004).
• Starting valve
Each cylinder has a starting valve with a solenoid valve (001). Each starting valve supplies
the related cylinder with the specified quantity of starting air at the correct time.
• Valve unit for start E
The valve unit for start E (008) supplies the starting air shut-off valve with control air.
• Disengaging device turning gear
When the turning gear is engaged, the disengaging device turning gear (006) closes the
shut-off valve in the supply pipe. This prevents the supply of control air to the valve unit for
start E, and thus prevents engine start.
• Flame arrestor
The flame arrestor (002) prevents combustion gas to flow back into the air pipe.
X92-B
AA00-0000-00AAA-043C-A
Operation Manual Starting air system
Winterthur Gas & Diesel Ltd.
- 80 - Issue 002 2021-11