VERSION 3
05/01/2021
I
NSTALLATION AND
U
SAGE
G
UIDE
WINESP40DUPRO
Page 22
-
Press the button
for one second till the set temperature flashes.
-
Use the button
to increase the temperature setting.
-
Use the button
to decrease the temperature setting.
-
When the setting is as required, press the button
to confirm.
Explanations of main symbols on the digital display:
Red
indicator lit on the display = cooling mode engaged (compressor)
Red
indicator lit on the display = high-speed ventilation during cooling mode
Red
indicator lit and message “DF” on the display = defrosting mode in progress
Red
indicator lit on the display = heating mode engaged (resistor)
4.2.2
STANDBY MODE
-
Putting the air conditioner on standby: keep button 1 pressed in for 3
seconds. The compressor will stop and the fan will switch to slow speed.
-
The thermostat will alternately display “OFF”
and the cellar temperature.
-
To exit the standby mode, keep button 1 pressed in for 3 seconds once again.
-
The thermostat will display “ON” for 1 second.
4.2.3
AUTOMATIC DEFROSTING
The thermostat is programmed to regularly carry out automatic defrosting. That
stops the compressor
,
and the
fan of the indoor unit continues to operate at slow speed
. Any condensate resulting from
defrosting is drained through the condensate pipe.
